iipp publishingJournal of Applied Engineering Science

Article

Fine turning of the vehicle formed components coated by the ultra-hard polycrystalline tools
ISSN: 1451-4117     
E-ISSN: 1821-3197    
DOI: 10.5937/jaes15-12834
This is an open access article distributed under the CC BY-NC-ND 4.0 terms and conditions. 
Volume 15, article 430, pages: 203 - 207

Klimenko Sergey Anatolievich*
Bakul Institute of hard materials of NAN of Ukraine, Kiev

Trofimov Igor Leonidovsch
Bakul Institute of hard materials of NAN of Ukraine, Kiev

Burykin Vitaliy Vitalievich
Bakul Institute of hard materials of NAN of Ukraine, Kiev

Prymak Liudmyla Borysivna
Bakul Institute of hard materials of NAN of Ukraine, Kiev

Ljubodrag Tanovic
University of Belgrade, Faculty of mechanical engineering, Belgrade, Serbia

The questions treatment cutting of the shaped details are considered with chromium-nickel coatings by lathe instruments, equipped polycrystalline ultra hard materials on the basis of cubic boron nitride of the coniferous forest. The features of technologies of lathe treatment of details are rotined with coverages at the improvement of structural descriptions of cutting plate, technological parameters of process of cutting and coverages on an instrument. It is set that application of sheeting allows to promote firmness of polycrystalline instruments on the stage of earning extra money due to diminishing of adhesive contact between the processed and instrumental materials.

View article

Klimenko, S.A., (2011). Processing by cutting processing of details with coatings. Kiev: Institute of Superhard Materials of National Academy of Sciences of Ukraine. (In Ukraine)

Mrochek, Zh. A., (2007). Treatment of wearproof coverages. Design ABOUT.

Novikov, N.V., Klimenko, S.A., (2006). Superhard materials. The preparation and use 6 units / Under the general editorship. - U. 5. Material Processing by blade tool. Institute of Superhard Materials of National Academy of Sciences of Ukraine. (In Russian)

Kogan, B.I., (2013). Progressive cuttings materials for lathe treatment of refurbishable surfaces details of machines. Kuzbas, GTU, 6, 58–65. (In Russian)

Mel’nichuk, Yu.A., Petrusha, I.A, Osipov, A.S., (2006). Technological possibilities of blade instrument, equipped diamond-ceramic plates. Technologists of tooling of materials, Kiev, ISM NANU, 51–55. (In Russian)

Manovickiy, A.S., (2012). The Cuttings plates from polikristal nitrid of the coniferous forest for the difficult type sharpening of rental rollers. Processes of tooling are in an engineer, 82–87. (In Ukraine)

Tabakov, V.P., Chikhranov, A.V., (2007). Wearproof coverages of toolpiece, working in the conditions of the continuous cutting. Ulianovsk. (In Russian)

Fomenko, R.N., (2009). Research of wearproof coverages of instrument on the different parameters of cutting process at sharpening. Ufa, T. 12., 4(33), 51–55. (In Russian)

Brito, R., Carvalho, S., Marcondes, S., (2009). Thermal analysis in coated cutting tools. International Communications in Heat and Mass Transfer.