ISSN: 1451-4117
E-ISSN: 1821-31977
Volume 2 number 6, pages: 35 - 42
The designing of the deep drawing technological process is traditionally based upon the “trial and error” method that is not rational in most of the cases for its being time consuming and expensive. The modern approach to the design in general as well as technological processes themselves assumes the use of computer and respective program packages and tools. In applying this approach, the design process can be automated while the technological process parameters can be optimized. The paper presents an application for designing the technology of the multi-step deep drawing of round cups (vessels) that should represent a part of an otherwise complex process for deep drawing technology and tool design. The application is created in the Visual Basic package for personal computers.
1. Akaro I.L. i dr.: Osnovnie termini i opredelenija v obrabotke metallov davleniem. '' Kuznečno-štampovočnoe proizvodstvo'', No 8, 1990.
2. Avitzur B.: Metal forming. Lehigh Univesity, Internet, http://metalforminginc. com /Publications /Papers /ref133 /ref133. htm
3. Jahnke H., Retzke R., Weber W.: Umformen und Schneiden. VEB Verlag Technik, Berlin, 1972.
4. Romanovskij V. P.: Spravočnik po holodnoj štampovke. Šestoe izdanie, prerabotannoe i dopolnennoe. ''Mašinostroenie'', Leningrad, 1979.
5. Musafija B.: Obrada materijala plastičnom deformacijom, Svjetlost, Sarajevo, 1988.
6. Park S.B., Choi Y. et al.: A Study of a computer-aided process design system for axisymmetric deep-drawing products. J. Mater. Process. Technol. 75 (1998).
7. Kawka M., Olejnik L. et al.: Simulation of wrinkling in sheet metal formingJ. Mater. Process. Technol. 109 (2001).
8. Stoiljković V., Milosavljević M.:Projektovanje podržano računarom, Mašinski fakultet, Niš, 1995.
9. Marinković V.: Mašinska obrada, Deo I,Mašinski fakultet, Niš, 1990.
10. Marčenko V.L. , Rudman L.I. , Zajčuk A.I. i dr.(Pod. obščej redakciej L.I.Rudmana): Spravočnik konstruktora štampov-Listovaja štampovka. ‘’Mašinostroenie’’, Moskva, 1988.
11. Marinković V., Janković Lj.: Automated design of the multi-layer deep drawing process of the conical parts with the flange. Journal for Technol. of Plasticity, Vol. 23, Number 1-2, 1999.
12. Norton P.: Visual Basic 6, Kompjuter Biblioteka ,Čačak, 2002.